
On this page
Top picks at a glance
As an Amazon Associate I earn from qualifying purchases.
- 1
Gallagher M120 Electric Fence Charger9.8/10View on Amazon - 2
Zareba 50 Mile AC-Powered Low Impedance Electric Fence9.7/10View on Amazon - 3
Plug-in 62 Mile Electric Fence Charger for Livestock9.7/10View on Amazon
Morning milking ends with a goat leaning on a fence wire that gives no buzz, and the herd already knows the boundary is down before the keeper does. Electric fence charger troubleshooting starts with that quiet wire: the charger, the ground and the fence line each get a check in turn, and the meter reading at each point shows where the power stops.
GoatGearLab earns a commission when you buy through links on this page, at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Affiliate disclosure.
Electric fence charger troubleshooting: the short answer
Work from the charger outward. Check that the charger has power and pulses, check the ground system, then walk the fence line with a meter and watch where the reading falls. A charger that pulses at the terminals but reads low at the far end points to the fence line, while a charger that reads low at its own terminals points to power or ground. The meter listings in this guide give the ranges to read with: from 300 volts on the low end to 15,000 volts on the high end.
Start at the charger
A charger needs power before it can pulse. The Gallagher digital meter listing notes that chargers run on battery, solar or mains power, so match the check to the power source: a mains charger needs its outlet live, a battery charger needs a charged battery, and a solar charger needs sun on the panel and a charged battery behind it. If the charger has an indicator light, watch for the pulse; a charger that stays dark has a power problem, not a fence problem.
Our best electric fence charger for goats roundup compares charger types for a goat fence, and the battery fence charger for small herds guide covers battery units for a small herd.
Read the voltage with a meter
A meter turns a guess into a number. Clip the ground probe into the earth, hook the meter to the wire, and read the voltage the fence carries. Neon meters show the range with lights, while digital meters show volts on a screen, and both kinds appear in the listings below.
| Meter | Range | Display | Power |
|---|---|---|---|
| L-FENCE | 2kV to 12kV | 8 neon lights | No batteries |
| Gallagher SmartFix | Voltage and current | Digital screen | 9V battery |
| ALLOSUN GK503B | 0.6kV to 7kV | Neon lamps | No batteries |
| M MINGYA | 0.2kV to 15kV | LCD with backlight | 9V battery included |
| allsun digital | 300V to 9.9kV | LCD | Battery not included |
| Gallagher Digital | 0 to 12,000 volts | Digital screen | 9V battery |
| FenceMate | Up to 15,000 volts | LCD | 9V battery included |
| ANDMON | 0 to 13kV | LED screen | Battery not included |
| CatemRC | 12kV max | 8 neon lights | Battery-free |
Range matters. The ALLOSUN meter reads from 0.6kV to 7kV, so a fence that carries more than 7kV will sit at the top of its scale, while the M MINGYA meter reads from 0.2kV to 15kV and the FenceMate meter (on Amazon) reads up to 15,000 volts. The Gallagher digital meter reads from 0 to 12,000 volts with 100 volt steps under 10kV and 1,000 volt steps above it, and the maker states a 9V battery life of 6 to 12 months. The ANDMON meter also reads battery voltage from 0 to 19.9 volts, which helps when a battery charger is the suspect.
Some meters shut themselves off to save the battery. The allsun digital meter shuts down after 4 seconds without a pulse, and the ANDMON meter turns off after about 4 seconds with no pulse. The allsun meter also wakes on a pulse and reads a pulse every 0.5 to 2 seconds. A meter that goes dark between readings may be saving power rather than broken, so wait for the next pulse before calling it dead.
Check the ground system
A weak ground gives a weak fence. The ground probe needs firm contact with damp earth, and the ground wire needs a clean, tight connection at the charger and at the rod. Our electric fence ground return wire guide covers the wire that carries the return path. If the ground is dry, the fence reading drops even when the charger pulses well, so pour water on the ground rod area and read again before changing anything else.
Walk the fence line
Vegetation on the wire drains power along the whole line. Walk the fence and look for grass, branches and fallen wire touching the line, and clear what touches it. Check insulators for cracks and look for wire that has slipped off a post, since a contact point can pull the reading down for the whole fence.
Work in sections when the reading is low everywhere. Disconnect the fence partway along the line and read each part on its own: the part that reads low holds the fault. The Gallagher SmartFix meter shows the direction of the fault with arrows, which narrows the walk to the stretch that needs it. A Gallagher Live Fence Indicator clips to the wire and flashes with each pulse when voltage exceeds 3,000 volts, and the maker states the flash is visible up to 3,000 feet away at night, so a dark indicator on a live stretch points to that stretch.
Match the meter to the fence
Neon meters and digital meters suit different jobs. A neon meter with 8 lights, such as the L-FENCE or the CatemRC, needs no battery and shows the range at a glance, but the ALLOSUN listing warns that neon light is hard to see in direct sun, so shade the lights with a hand to read them. A digital meter shows an exact figure, which helps when comparing readings along the line, and the M MINGYA and FenceMate meters add a backlight or a large screen for low light.
Check the battery question before buying. The L-FENCE and CatemRC meters (on Amazon) need no batteries, the M MINGYA and FenceMate meters include a 9V battery, and the allsun digital and ANDMON meters ship without a battery. The ALLOSUN meter lists an operating range of 0 to 40 degrees Celsius and a storage range of minus 20 to 50 degrees Celsius, so a meter left in a hot truck or a freezing barn may read oddly until it warms up.
Warranty terms vary. The Gallagher SmartFix, allsun digital and ANDMON meters each state a 1 year warranty, while the ALLOSUN meter states 12 months of warranty with lifetime support.
FAQs from goat keepers
Why does an electric fence charger show no voltage?
Check power, then ground, then the meter. A mains charger needs a live outlet, a battery charger needs a charged battery, and a meter with a dead 9V battery reads nothing at all. If the charger pulses at its terminals but the fence reads low, the fault sits on the fence line.
Which meter range fits a fence?
Match the range to the fence voltage. The ALLOSUN meter reads 0.6kV to 7kV, the L-FENCE meter reads 2kV to 12kV, the M MINGYA meter reads 0.2kV to 15kV, and the FenceMate meter reads up to 15,000 volts. A fence that reads at the top of a small meter’s scale may carry more than the meter can show.
Why does the voltage drop along the fence line?
Vegetation, a cracked insulator, or wire touching a post drains power along the line. Walk the fence, clear what touches the wire, and read again. The Gallagher SmartFix meter shows the direction of the fault with arrows, which narrows the walk to the stretch that needs it.
Do fence meters need batteries?
Some do and some do not. The L-FENCE and CatemRC meters need no batteries, the M MINGYA and FenceMate meters include a 9V battery, and the allsun digital and ANDMON meters ship without a battery. The Gallagher digital meter includes a 9V battery with a stated life of 6 to 12 months.
How do you find a short in the fence?
Read the fence in sections and follow the low reading. A Live Fence Indicator that stays dark on a stretch while the rest flashes points to that stretch, since it flashes when voltage exceeds 3,000 volts. Clear vegetation, check insulators, and read again after each fix.
More from the barn
See every fence charger guide and all fencing and shelter guides.
More picks: best electric fence chargers for goats, battery fence chargers for small herds, fence chargers for large goat pastures and electric fence ground return wire.
