
On this page
Top picks at a glance
As an Amazon Associate I earn from qualifying purchases.
- 1
Hay Moisture Tester with 20" ProbeView on Amazon - 2
Digital Portable Hay Moisture Meter Tester with 15.7" ProbeView on Amazon - 3
𝙐𝙥𝙜𝙧𝙖𝙙𝙚 TK100H Hay Moisture TesterView on Amazon - 4
ZOEYEC TK100H Portable Hay Moisture Meter for Cereal StrawView on Amazon - 5
Pokiphip TK100H Portable Hay Moisture MeterView on Amazon - 6
TK100H Portable Hay Moisture Tester ProbeView on Amazon
Hay comes off the field in the morning, gets stacked in the barn by afternoon, and sits there holding whatever damp it carried in from the meadow, so knowing what is inside a bale matters before the stack grows tall. Learning how to use a moisture meter means pushing a probe into the bale, reading the moisture and temperature on the display, and checking the reading against the meter range before the hay goes into storage. This guide walks through the steps using the figures the meter listings publish, so the numbers below come from the listings themselves.
Also worth comparing
Hay Moisture Tester with 20" ProbeCheck price on Amazon
Digital Portable Hay Moisture Meter Tester with 15.7" ProbeCheck price on Amazon
𝙐𝙥𝙜𝙧𝙖𝙙𝙚 TK100H Hay Moisture TesterCheck price on Amazon
ZOEYEC TK100H Portable Hay Moisture Meter for Cereal StrawCheck price on Amazon
Pokiphip TK100H Portable Hay Moisture MeterCheck price on Amazon
TK100H Portable Hay Moisture Tester ProbeCheck price on Amazon
GoatGearLab earns a commission when you buy through links on this page, at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Affiliate disclosure.
How to use a moisture meter: the short answer
Start with the calibration clip, then push the probe straight into the bale, hold the read button, and note the moisture and temperature on the display. The Courdom and Fynoyf listings give a moisture range of 8 to 45 percent and a temperature range of 32 to 210 degrees Fahrenheit, while the Runant TK100H (on Amazon) listing gives a moisture range of 0 to 80 percent with an error range of 0.5 percent. Check the reading in more than one spot in the bale, since the Fynoyf listing supports readings in several bale locations for a steadier field reference.
If the reading looks high, hold the hay out of the barn and check again after the bale has had time in the air. For keeping stored hay dry once it passes the check, the best hay tarps guide covers tarps and anchors for the stack.
Probe length and meter ranges compared
Probe length decides how far into the bale the meter can reach, and the stated range decides which readings the meter can show at all. The listings below give the figures the makers publish.
| Meter | Probe | Moisture range | Temperature range |
|---|---|---|---|
| Courdom HT-M | 20 inch probe | 8 to 45 percent | 32 to 210 degrees Fahrenheit |
| Courdom HT-Pro | 20 inch probe | 8 to 45 percent | 32 to 210 degrees Fahrenheit |
| Fynoyf HT | 20 inch probe | 8 to 45 percent | 32 to 210 degrees Fahrenheit |
| AgraTronix HT-Pro | 20 inch probe | 8 to 44 percent | Not stated |
| Soonkoda HM-B | 15.7 inch probe | 3 to 40 percent | Not stated |
| Runant TK100H | Not stated | 0 to 80 percent | Display stated, range not stated |
Long probes reach the bale core
The Courdom, Fynoyf and AgraTronix listings all give a 20 inch reinforced stainless steel probe, built to push into dense square or round bales and read moisture below the surface. The Courdom listing adds a backlit LCD display, glove-friendly buttons and a 3 minute auto shutoff, plus a carry bag and a calibration clip in the kit. The AgraTronix listing gives a weight of 2.0 pounds and dimensions of 2.0 by 30.0 by 7.0 inches, with an illuminated LCD display and above and below moisture limit indications.
Short probes and wide ranges
The Soonkoda listing gives a 15.7 inch probe in the title and a probe length of 40 cm with a total length of 58 cm in the bullets, a moisture range of 3 to 40 percent, and power from 4 AA batteries. The listing gives a resolution of 0.1 percent below 20 percent and a resolution of 1 percent at 20 percent or higher, with a CAL button that adjusts the moisture value from -9 to 16. The Runant TK100H listing gives a moisture range of 0 to 80 percent, an error range of 0.5 percent, automatic temperature compensation, and a conductivity working principle.
Meters that read temperature too
The Courdom and Fynoyf listings read temperature from 32 to 210 degrees Fahrenheit alongside moisture, which helps when checking stored hay for internal heat during routine storage checks. The Runant listing states that its screen detects real-time temperature, while the kalageen TK100H (on Amazon) listing states an operating range of -10 to 60 degrees Celsius and also states that the meter cannot measure temperature, so read that listing with care. A backlit display shows up across the listings, which helps in a dark barn or in early morning light.
Push the probe in straight and deep
The Soonkoda listing gives the clearest operating steps: insert the probe vertically and quickly into the hay, press and hold the red button on the handle, and watch the screen change from P1 to the measured moisture value. Use the same technique for repeated readings of the same material, since the listing states that a steady technique keeps the readings consistent. The Runant listing adds that the probe should go straight into the haystack and that a deeper insertion gives a more accurate value. The kalageen listing states that the whole operation takes less than 1 minute and that the measurement value shows in real time.
Check the calibration clip first
The Courdom, Fynoyf and AgraTronix listings include a calibration clip for verifying readings before use, with a reference value of 24.7 percent plus or minus 1.5 percent on the Courdom listings. Use the clip on a truck tailgate, workbench or barn shelf before the first bale of the day, and repeat the check when the readings start to look off. A meter that reads far from the reference value needs attention before it can be trusted on a bale.
Batteries, display and shutoff
Power differs by listing. The Courdom kit runs on 1x 9V battery, not included, while the Soonkoda meter (on Amazon) runs on 4 AA batteries, with a battery cover opened by pressing the buckle on the side of the instrument. The Courdom listing gives a 3 minute auto shutoff, the Fynoyf listing gives an auto power-off function, and the Pokiphip and kalageen listings give a choice of manual and auto power off. Backlit LCD displays appear across the listings, and the Courdom listing notes large glove-friendly buttons for work with gloves on.
Read the listing twice
Moisture meter listings contradict themselves, and the numbers that conflict are usually the ones that matter for the reading:
- Courdom HT-M and HT-Pro: identical bullets, identical ranges and identical calibration figures, so the listings read as the same meter under the HT-M and HT-Pro model names.
- Fynoyf: the listings repeat the same bullets and ranges, in black and in black and yellow, so color is the only stated difference.
- AgraTronix HT-Pro: a moisture range of 8 to 44 percent, against 8 to 45 percent on the Courdom and Fynoyf listings for the same 20 inch probe.
- Soonkoda HM-B: a 15.7 inch probe in the title against a probe length of 40 cm and a total length of 58 cm in the bullets.
- kalageen TK100H: an operating range of -10 to 60 degrees Celsius, while the same listing states the meter cannot measure temperature.
- ZOEYEC TK100H (on Amazon): a weight given as 0.22 pounds in the spec table, a figure with far more decimal places than any other listing gives.
Check the title and bullets before trusting the spec table, and allow for the wider range when the listings disagree.
What this guide does not cover
This guide covers meter hardware and the reading steps only. It does not cover how much hay a goat needs, hay types, storage design or any health question. Ask a veterinarian or local extension office about rations and goat health.
FAQs from goat keepers
How deep should the probe go into a bale?
Push the probe straight in and as deep as the probe allows. The listings with a stated probe length give a 20 inch probe on the Courdom, Fynoyf and AgraTronix meters and a 15.7 inch probe on the Soonkoda meter, and the Runant listing states that a deeper insertion gives a more accurate value.
What moisture range should a hay moisture meter read?
Ranges differ by listing. The Courdom and Fynoyf listings read 8 to 45 percent, the AgraTronix listing reads 8 to 44 percent, the Soonkoda listing reads 3 to 40 percent, and the Runant and kalageen TK100H listings read 0 to 80 percent.
How do you check a moisture meter before use?
Use the calibration clip included with the Courdom, Fynoyf and AgraTronix listings. The Courdom listings give a reference value of 24.7 percent plus or minus 1.5 percent, so a reading near that value shows the meter is set right.
What batteries do hay moisture meters use?
It depends on the listing. The Courdom kit runs on 1x 9V battery, not included, and the Soonkoda meter runs on 4 AA batteries. Other listings do not state a battery type, so check the listing before ordering spares.
More from the barn
See every hay feeder guide and all hay net guides.
More picks: best hay tarps, slow feeding hay nets, goat mineral feeders and water trough heaters.
