
On this page
Top picks at a glance
As an Amazon Associate I earn from qualifying purchases.
- 1
ZESHANGUS Cattle Panel 4x165ft9.7/10View on Amazon - 2
Danbark Sorting Panel 38x309.5/10View on Amazon - 3
Rustark Gridwall Joining Clips9.5/10View on Amazon - 4
KHEARPSL Sorting Panel 38x309.4/10View on Amazon
A goat leans on the fence at feeding time, a hog roots along the bottom rail, and the panel between them has to hold its shape through both. That is the daily chore behind hog panel size: the height and length of the panel, and the size of the mesh openings, decide whether the fence fits the pen and the animals in it. This guide points out where those listings disagree with themselves.
GoatGearLab earns a commission when you buy through links on this page, at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Affiliate disclosure.
| # | Product | GoatGear Score | Buy |
|---|---|---|---|
| 1 | ZESHANGUS Cattle Panel 4x165ft | 9.7/10 | Buy on Amazon |
| 2 | Danbark Sorting Panel 38x30 | 9.5/10 | Buy on Amazon |
| 3 | Rustark Gridwall Joining Clips | 9.5/10 | Buy on Amazon |
| 4 | KHEARPSL Sorting Panel 38x30 | 9.4/10 | Buy on Amazon |

ZESHANGUS Cattle Panel 4x165ft
A 4 ft by 165 ft woven wire cattle panel roll in 14 gauge galvanized steel with a 12 gauge border and mesh openings from 8 inches to 3.5 inches.
Pros
- 4 ft by 165 ft roll covers long fence runs from one roll
- 14 gauge wire with a 12 gauge reinforced border
- Mesh tapers from 8 inches at the top to 3.5 inches at the bottom
- Hot-dip galvanized surface stated for rust and weather protection
Cons
- No warranty term is stated
- Service life drops to 10 to 15 years in extreme conditions
- No sorting or handling use is stated for this roll

Danbark Sorting Panel 38x30
A lightweight polyethylene livestock sorting panel with a paddle, rounded hand grips and a medium 38 by 30 inch size in red.
Pros
- Medium 38 by 30 inch size stated in the title and spec table
- Rounded hand grips allow one-handed operation
- Polyethylene surface resists dirt and rinses with soap and water
- Built for hogs, sheep, goats and cattle
Cons
- No warranty term is stated
- No weight figure is stated
- No thickness figure is stated
- A 38 by 30 inch panel does not serve as a fence

Rustark Gridwall Joining Clips
A pack of 30 sets of stainless steel grid panel joining clips, each set with a large piece, a small piece, a screw and a hex flange nut.
Pros
- 30 sets in the pack, 120 pieces in total
- Stainless steel with a zinc-plated surface, rust and corrosion resistant
- Large piece 1.33 inches by 0.73 inches and small piece 1 inch by 0.78 inches stated
- Fits wire diameter from 4 to 6 mm, 0.16 to 0.24 inches
Cons
- No warranty term is stated
- Clips join grid panels; they are not panels themselves
- Listing names gridwall displays and wire grids, not woven wire cattle panels
- Each clip piece is about 1 inch long, so it suits small wire only

KHEARPSL Sorting Panel 38x30
A red livestock sorting panel with handles on both sides, a concave face and a stated size of 38 by 30 inches with 1.34 inch thickness.
Pros
- Handles on both sides for control
- Concave design stated to disperse impact force
- Smooth back and smooth edges stated
- 1.34 inch thickness stated in the title
Cons
- No warranty term is stated
- Title says 30 inches wide and the bullets say 33 inches wide
- No weight figure is stated
- No material is named in the listing
As an Amazon Associate I earn from qualifying purchases.
Also worth comparing
Fencer Wire 3' x 150' Cattle PanelCheck price on Amazon
ProWood Black Powder-Coated Hog Wire Metal PanelCheck price on Amazon
Hog panel size: the short answer
In the listings in this guide, hog panel size takes several forms. A woven wire cattle panel roll measures 4 ft by 165 ft, with mesh openings from 8 inches at the top to 3.5 inches at the bottom. A livestock sorting panel measures 38 by 30 inches, with a 1.34 inch thickness on the KHEARPSL listing. Clips for joining grid panels come in 30 sets, with a large piece of 1.33 inches by 0.73 inches and a small piece of 1 inch by 0.78 inches. If you want the wider comparison, our hog panels vs goat panels guide compares panel types for goats and hogs.
Hog panel sizes in this guide
| Product | Stated size | Material | Amazon |
|---|---|---|---|
| ZESHANGUS cattle panel roll | 4 ft x 165 ft | 14 gauge galvanized steel | |
| Danbark sorting panel | 38 x 30 in | Polyethylene | |
| KHEARPSL sorting panel | 38 x 30 in in the title, 38 x 33 in in the bullets | Not stated | |
| Rustark joining clips | 1.33 x 0.73 in large piece, 1 x 0.78 in small piece | Stainless steel |
The table shows the spread: a roll for fence lines, a handled board for moving animals, and clips for joining panels.
Mesh openings: 8 inches to 3.5 inches
The ZESHANGUS roll states mesh openings that taper: 8 inches at the top down to 3.5 inches at the bottom. The wider top keeps the view open, while the tighter bottom leaves less room for small animals to slip through. The listing pairs that taper with 14 gauge wire and a 12 gauge reinforced border, and a hot-dip galvanized surface for rust and weather protection. Read the bottom figure when small stock is the concern: 3.5 inches, not 8 inches.
Panel length and height
The roll measures 4 ft by 165 ft, which makes it a fence-line product: it rolls out along a run and fastens to posts, and the listing says it sets up fast with no special tools and that one person can handle it. The listing also states a service life of 15 to 20 years in normal environments and 10 to 15 years in extreme conditions. Treat the low end as the planning figure when the fence faces harsh weather. Our best cattle panel fence roundup scores wire rolls and picket kits on the same points.
Sorting panels: 38 by 30 inches
The sorting panels in this guide state the same footprint: 38 by 30 inches. The Danbark panel (on Amazon) adds a paddle, rounded hand grips and a non-porous polyethylene surface that rinses with soap and water, and it lists hogs, sheep, goats and cattle. The KHEARPSL panel adds handles on both sides, a concave face and a smooth back, and lists the same animals. Weight is not stated for these panels. A sorting panel is a handling board, not a fence: it guides animals through a gate or pen, and it does not stand in for a wire panel on a fence line.
Joining clips and panel hardware
Panels meet at joints, and the Rustark listing covers that joint: 30 sets of stainless steel clips, each set with a large piece, a small piece, a screw and a hex flange nut. The large piece measures 1.33 inches by 0.73 inches and the small piece measures 1 inch by 0.78 inches, sized for wire diameter from 4 to 6 mm, or 0.16 to 0.24 inches. The listing names gridwall displays and wire grids as the use. Clips are hardware, not panels: they hold panels together, and they add no height or length of their own.
Read the listing twice
Listings in this guide disagree with themselves on size:
- KHEARPSL: 30 inches wide in the title and the model line, 33 inches wide in the bullets.
- ZESHANGUS: 4 ft by 165 ft in the title, 8.07 inches in the spec table product dimensions.
- Rustark: 1.33 inches and 1 inch clip pieces in the bullets, 1.0 inch in the spec table product dimensions.
Trust the title and the bullets over the spec table. The Danbark listing agrees on 38 by 30 inches in its title, bullets and spec table.
Gear for hog panel size jobs
Panel size decides the fence line, and the gear below handles the work that size creates: the roll, the sorting boards and the clips.
FAQs from goat keepers
What size is a hog panel?
In the listings in this guide, a woven wire cattle panel roll measures 4 ft by 165 ft, and a livestock sorting panel measures 38 by 30 inches. Mesh openings on the roll run from 8 inches at the top to 3.5 inches at the bottom.
How tall is a hog panel?
The roll in this guide stands 4 ft tall, and the sorting panels measure 38 by 30 inches.
What gauge wire is used in hog panels?
The cattle panel roll in this guide uses 14 gauge galvanized wire with a 12 gauge reinforced border.
What size clips join grid panels?
The Rustark clips (on Amazon) in this guide come in 30 sets, with a large piece of 1.33 inches by 0.73 inches and a small piece of 1 inch by 0.78 inches, sized for wire diameter from 4 to 6 mm.
How long does a galvanized cattle panel last?
The ZESHANGUS listing states 15 to 20 years in normal environments and 10 to 15 years in extreme conditions.
More from the barn
See every goat fencing wire guide and all fencing and shelter guides.
More picks: best cattle panel fence, best hog panel gate, hog panels vs goat panels and fence repair kit.
