
On this page
Top picks at a glance
As an Amazon Associate I earn from qualifying purchases.
- 1
VEVOR 32 in T Post Puller9.7/10View on Amazon - 2
Dolibest 36 in Post Puller9.6/10View on Amazon - 3
Insaga 36 in T Post Puller9.5/10View on Amazon - 4
TUGNOSTI 36 in T Post Puller9.5/10View on Amazon
A fence post that leans after a storm leaves a gap in the line, and a manual t post puller lifts that post out of the ground with a lever and a chain. The tool grips the post, rests a wide base on the ground and turns a push on the handle into upward force on the post. This guide explains how the puller works, what to check in the handle, the base, the load rating and the chain, and compares the pullers in the gear section below.
GoatGearLab earns a commission when you buy through links on this page, at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Affiliate disclosure.
| # | Product | GoatGear Score | Buy |
|---|---|---|---|
| 1 | VEVOR 32 in T Post Puller | 9.7/10 | Buy on Amazon |
| 2 | Dolibest 36 in Post Puller | 9.6/10 | Buy on Amazon |
| 3 | Insaga 36 in T Post Puller | 9.5/10 | Buy on Amazon |
| 4 | TUGNOSTI 36 in T Post Puller | 9.5/10 | Buy on Amazon |

VEVOR 32 in T Post Puller
A steel puller with a 43 in lifting chain and a stated load rating of 661 lbs, built around a widened base.
Pros
- Stated load rating of 661 lbs, the highest in this guide
- 43 in lifting chain included in the listing
- Widened base for greater ground contact
- Powder-coated steel resists rust and wear
Cons
- No warranty term is stated
- Stated weight of 18.52 pounds, the heaviest in this guide
- No handle grip detail is stated

Dolibest 36 in Post Puller
A steel puller with a 36 in handle, a stated load rating of 660 lbs and a 5MM thickened base.
Pros
- Stated load rating of 660 lbs
- 5MM thickened base locks firmly to the ground
- 18MM one-piece claw with a hardened alloy steel hook
- Round rubberized grip with a non-slip rubber sheath
Cons
- Chain not included
- No warranty term is stated
- Listed weight of 4.41 pounds, far below the VEVOR at 18.52 pounds

Insaga 36 in T Post Puller
A carbon steel puller with a 36 in fixed handle, an anti-slip grip and a wider base plate.
Pros
- 36 in one-piece handle for leverage
- Anti-slip grip holds in wet, muddy or freezing conditions
- Wider base plate distributes weight evenly
- Foldable design for easy storage
Cons
- No load rating is stated
- Chain sold separately
- No weight is stated
- No warranty term is stated

TUGNOSTI 36 in T Post Puller
A steel puller with a 36 in frame, a widened base and a simple lock-and-push action for posts and small stumps.
Pros
- Widened base for greater ground contact
- Powder-coating helps prevent wear
- Handles T-posts, wooden posts, cement plugs and small stumps
- Simple lock-and-push action with no power equipment
Cons
- No load rating is stated
- Lifting chain not included
- No weight is stated
- No warranty term is stated
As an Amazon Associate I earn from qualifying purchases.
Also worth comparing
Osistga Fence Post PullerCheck price on Amazon
T‑Post PullerCheck price on Amazon
T Post PullerCheck price on Amazon
Hi-Lift Post-Popper Post Puller PP-300Check price on Amazon
BISupply T Post Puller Fence Post PullerCheck price on Amazon
36" T-Post Puller Fence Post PullerCheck price on Amazon
How to use a manual t post puller: the short answer
A manual t post puller is a lever tool that lifts a fence post straight out of the ground, with no power equipment. Hook the chain or claw around the post, set the wide base flat on firm ground, push the handle down to lift the post, then reset the grip lower on the post and push again. The TUGNOSTI listing describes exactly that action: lock the puller around the stud, push the handle down to pull the post upward, then raise the handle and fit it around a lower stud.
A T-post, a round metal post, a wooden stake or a sign post all suit these pullers, and the listings also cover small tree stumps. Then check the handle length, the base width, the stated load rating and whether the chain comes in the box. The how to remove a fence post guide covers the full removal job.
How a manual t post puller works
The puller turns a long handle into lifting force. The VEVOR listing describes a lever effort-saving mechanism, and the Dolibest listing pairs a reinforced steel frame with a 5MM thickened base. The grip comes from a chain or a claw: the VEVOR ships with a 43 in lifting chain, the Dolibest uses an 18MM one-piece claw with a hardened alloy steel hook, and the Insaga and TUGNOSTI listings leave the chain out of the box.
Handle length, base and chain: what to check
Handle length sets the leverage, the base sets the stability and the chain sets what the puller can grip. The table below lists the stated handle length, load rating and chain for each puller.
| Puller | Handle | Load rating | Chain | Amazon |
|---|---|---|---|---|
| VEVOR 32 in T Post Puller | 32 in | 661 lbs | 43 in chain included | View on Amazon |
| Dolibest 36 in Post Puller | 36 in | 660 lbs | Not included | View on Amazon |
| Insaga 36 in T Post Puller | 36 in handle | Not stated | Sold separately | View on Amazon |
| TUGNOSTI 36 in T Post Puller | 36 in | Not stated | Not included | View on Amazon |
Handle length
The Insaga, TUGNOSTI and Dolibest listings state a 36 in handle, while the VEVOR title states 32 in. The Insaga listing calls its handle a solid one-piece design that gives leverage without bending or flexing, and the Dolibest listing adds an external square steel sleeve over the handle-to-bracket connection to spread stress and prevent twisting or bending under heavy loads.
Base width
Every listing here describes a widened base, and the reason is the same in each: the base spreads the load so the tool does not sink or tip while the handle goes down. The VEVOR and TUGNOSTI listings say the widened base provides greater ground contact and avoids sinking or tipping, and the Dolibest listing states a 5MM thickened base.
Chain or claw
The chain or claw is the part that grips the post, and it is the part most often left out of the box. The VEVOR listing includes a 43 in lifting chain, the Insaga listing says the chain is sold separately, and the TUGNOSTI and Dolibest listings state the chain is not included. The Dolibest claw is an 18MM one-piece design with a hardened alloy steel hook that grips chains or ropes, so a keeper who already owns a heavy chain can use it with that puller.
Reading the load rating
The load rating states how much weight the puller supports without bending. The VEVOR listing states 661 lbs (300 kg), and the Dolibest listing states 660 lbs. The Insaga and TUGNOSTI listings state no load rating.
Check the listing before ordering
Puller listings contradict themselves on the numbers needed to plan the job:
- VEVOR: 32 in in the title against 33.31 x 5.91 x 5.91 inches in the spec table.
- Dolibest: 36 inch in the title against 37.4 x 36.22 x 1.97 inches in the spec table.
- Insaga: a 36 in handle in the bullets against 36.3 x 5.7 x 36.0 inches in the spec table.
The Dolibest listing states a weight of 4.41 pounds, while the VEVOR listing states 18.52 pounds.
What this guide does not cover
This guide covers puller hardware only. For setting the replacement post, the how to put in a fence post guide covers the tools and the steps.
The gear we picked
The pullers below handle the lifting step above, from the chain grip on the post to the base that holds the ground.
Every spec repeats the brand’s rating from its listing (collected on 10 November 2026).
FAQs from goat keepers
How does a manual t post puller work?
The puller grips the post with a chain or claw, rests a wide base on the ground and turns a push on the handle into upward force. The TUGNOSTI listing describes the action: lock the puller around the stud, push the handle down to pull the post upward, then raise the handle and fit it around a lower stud.
What handle length do manual t post pullers have?
The listings here state 32 in for the VEVOR and 36 in for the Insaga, TUGNOSTI and Dolibest pullers (on Amazon). The Insaga handle (on Amazon) is a solid one-piece design, and the Dolibest adds a square steel sleeve over the handle-to-bracket connection.
Do manual t post pullers come with a chain?
Only the VEVOR listing includes a chain, a 43 in lifting chain. The Insaga listing says the chain is sold separately, and the TUGNOSTI and Dolibest listings state the chain is not included.
How much weight can a manual t post puller lift?
The VEVOR listing states 661 lbs (300 kg), and the Dolibest listing states 660 lbs. The Insaga and TUGNOSTI listings state no load rating.
Can a manual t post puller remove a tree stump?
The listings say yes for small stumps. All 4 listings name tree stumps among the jobs, and the Insaga and TUGNOSTI listings say small tree stumps.
More from the barn
See every post driver and puller guide and all fencing and shelter guides.
More picks: manual fence post drivers, how to remove a fence post, fencing wire and heavy duty fence staples.
