Skip to content
We independently pick everything we recommend. We earn a commission when you buy through our links, at no extra cost to you. Learn more ›
Amazon Black Friday Week deals

Hand vs Gas Post Driver: Which One Should You Buy?

Hand vs gas post driver: two hand drivers and two Titan gas drivers compared on drive weight, engine power, beats per minute, post size and adapter collars.

Top picks

As an Amazon Associate I earn from qualifying purchases.

How we score

Hand vs Gas Post Driver: Which One Should You Buy?
On this page

Top picks at a glance

As an Amazon Associate I earn from qualifying purchases.

  1. 1Titan PGD3875 GasTitan PGD3875 Gas9.5/10View on Amazon
  2. 2Titan PGD2875 GasTitan PGD2875 Gas9.4/10View on Amazon
  3. 3LADECH 12 Lb HandLADECH 12 Lb Hand9.4/10View on Amazon
  4. 4MTB 34 Lb HandMTB 34 Lb Hand9.3/10View on Amazon

The hand vs gas post driver question comes up the morning a goat leans on a sagging fence line and the whole run needs new posts before evening chores. A hand driver is a weighted pipe lifted and dropped over each post until it sets. A gas driver is an engine that pounds the post while the keeper guides it. This comparison looks at hand and gas listings side by side on drive weight, engine power, beats per minute, post size and what each page leaves unclear,

GoatGearLab earns a commission when you buy through links on this page, at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Affiliate disclosure.

Quick verdict: choose the hand side if the fence line is short and the posts are T posts or U posts, as the LADECH example shows. Choose the gas side if the line is long and the ground is hard, as the Titan examples show at 30 and 50 lbs. Read this as a comparison of power sources first and of models second.

Two examples

Titan PGD3875 Gas

Titan PGD3875 Gas

Titan Post Drivers9.5/10 GoatGear Score
i
The GoatGear Score runs from 0 to 10 and weighs performance (35%), build (25%), value (25%), safety (10%, where it applies) and warranty (5%), using only what the manufacturer and the listing publish. How we pick ›

A self-contained 1.3 HP 4-stroke gas post driver at 50 lbs, driving posts, pipes, rods and stakes up to 3 7/8 inches at 700 to 1,350 beats per minute.

Pros

  • 1.3 HP 4-stroke engine, self-contained with no hoses or cords
  • 700 to 1,350 beats per minute for fast post driving
  • Drives posts, pipes, rods and stakes up to 3 7/8 inches
  • 4 adapter collars (1, 2, 3 and 4 inch) and a protective case

Cons

  • 50 lbs, the heaviest driver here
  • Light-duty only, not recommended for commercial use
  • No warranty term is stated
  • Engine needs fuel and pull-starts, unlike a hand driver
Titan PGD2875 Gas

Titan PGD2875 Gas

Titan Post Drivers9.4/10 GoatGear Score
i
The GoatGear Score runs from 0 to 10 and weighs performance (35%), build (25%), value (25%), safety (10%, where it applies) and warranty (5%), using only what the manufacturer and the listing publish. How we pick ›

A 30 lb 1.3 hp 4-stroke gas post driver running 1,500 to 2,000 beats per minute and fitting posts up to 3 inches.

Pros

  • 30 lbs, the lightest gas driver in this comparison
  • 1,500 to 2,000 beats per minute from a 1.3 hp 4-stroke
  • Fits posts up to 3 inches with 4 adapter collars
  • Includes engine oil and extra lube in the box

Cons

  • No warranty term is stated
  • Smaller 3 inch max post size than the PGD3875
  • Still 30 lb to carry, against 12 lb for the lightest hand driver
LADECH 12 Lb Hand

LADECH 12 Lb Hand

LADECH9.4/10 GoatGear Score
i
The GoatGear Score runs from 0 to 10 and weighs performance (35%), build (25%), value (25%), safety (10%, where it applies) and warranty (5%), using only what the manufacturer and the listing publish. How we pick ›

A 12 lb hand post driver, 17 inches long with an 8.5 inch handle width, built from 0.16 inch powder-coated steel for T posts, U posts and garden fence.

Pros

  • 12 lbs, light enough to work without much effort
  • 17 inch length with 8.5 inch handle width for control
  • 0.16 inch thick steel tube with powder coating
  • Simple design, easy to store on a shelf

Cons

  • No warranty term is stated
  • Manual pounding on every post, no engine help
  • Garden fence and T posts only, no stated wooden-post use
MTB 34 Lb Hand

MTB 34 Lb Hand

MTB Supply9.3/10 GoatGear Score
i
The GoatGear Score runs from 0 to 10 and weighs performance (35%), build (25%), value (25%), safety (10%, where it applies) and warranty (5%), using only what the manufacturer and the listing publish. How we pick ›

A 34 lb hand post driver, 24 inches long with 2 handles and a 6.14 inch inside diameter, in black powder-coated steel for T posts, U posts and wooden posts.

Pros

  • 34 lb drive weight lets the weight do the work
  • 2 loop handles for gripping
  • 6.14 inch inside diameter fits T posts, U posts and wooden posts
  • Black powder-coated steel against chipping and rust

Cons

  • No warranty term is stated
  • 34 lbs is the heaviest manual lift here

As an Amazon Associate I earn from qualifying purchases.


Also worth comparing

Hand vs gas post driver: side by side

Driver GoatGear Score Power Drive weight Post size Extras Amazon
Titan PGD3875 Gas 9.5/10 1.3 HP 4-stroke gas 50 lbs Up to 3 7/8 in 4 adapter collars, protective case View on Amazon
Titan PGD2875 Gas 9.4/10 1.3 hp 4-stroke gas 30 lb Up to 3 in 4 adapter collars, engine oil View on Amazon
LADECH 12 Lb Hand 9.4/10 Manual 12 lbs U posts, T posts Not stated View on Amazon
MTB 34 Lb Hand 9.3/10 Manual 34 lb T posts, U posts, wooden posts 2 handles View on Amazon

Sizes and capacities are the manufacturer’s numbers as each listing states them, pulled 22 October 2026.

How each side drives a post

A hand driver is muscle and gravity. The LADECH listing describes the method plainly: set the post, slide the driver over it and hammer until it reaches depth, with a 12 lb pipe doing the striking. The MTB listing makes the same point with more weight: lift the 34 lb driver over the post and let it drop. No fuel, no pull cord, nothing to maintain beyond the steel tube.

A gas driver replaces the lifting with an engine. The Titan PGD3875 runs a 1.3 HP 4-stroke at 700 to 1,350 beats per minute, and the PGD2875 runs the same 1.3 hp 4-stroke at 1,500 to 2,000 beats per minute. Both Titan listings describe ergonomic handles, and the PGD3875 adds a recoil pull-start and an integrated stop switch. For the broader choice between engine types, see our gas vs battery post driver comparison.

Drive weight against engine power

Weight means opposite things on the two sides. On the hand side, the weight is the tool: 12 lbs on the LADECH against 34 lb on the MTB. The heavier pipe hits harder per drop, but the keeper lifts it every time. On the gas side, the weight is the burden: 50 lbs on the PGD3875 against 30 lb on the PGD2875, and no pound of it does the driving, the 1.3 HP engine does. So a gas driver can weigh more than a hand driver while asking less of the keeper’s arms.

That trade pays off on longer lines: the engine’s beats per minute add up against one lift-and-drop at a time.

Post sizes and adapter collars

Hand drivers fit by inside diameter. The MTB listing gives a 6.14 inch inside diameter and names T posts, U posts and wooden posts. The LADECH listing names metal U posts, T posts and garden fence without stating a diameter, so larger wooden posts are a question for the seller.

Gas drivers fit by adapter collar. The PGD3875 drives posts, pipes, rods and stakes up to 3 7/8 inches and ships 1, 2, 3 and 4 inch collars. The PGD2875 fits posts up to 3 inches with 1, 1.77, 2 and 3 inch collars. Match the collar to the post before the first start, and for wooden posts specifically see our post drivers for wood posts picks.

Listing gaps to check

Two listings contradict themselves. The MTB spec table lists 18 pounds, 16.15 inches and a Corded Electric power source where the title and bullets say 34 lb, 24 inches and a hand tool; the title and bullets win. The LADECH table says 11.84 pounds against the 12 lb title and bullets, a small gap with the same verdict. The PGD2875 table carries drill-like fields, 2000 rpm and 120 kilovolts, that do not describe a post driver and should be ignored.

No listing states a warranty term, so none earns warranty points. Only the PGD3875 states a safety-relevant feature, its integrated stop switch. If the warranty or a missing figure decides the purchase, ask the seller before ordering.

Which should you choose?

Choose a hand post driver if the fence line is short, the posts are T posts or U posts, and you would rather lift a pipe than maintain an engine, as the 12 lb LADECH shows. A hand driver needs no fuel, makes no noise and stores on a shelf.

Choose a gas post driver if the line is long, the ground is hard, and an engine doing the pounding beats lifting a pipe all afternoon, as the two Titan examples show at 30 and 50 lbs with 1.3 HP 4-stroke engines. The PGD2875 is the lighter carry; the PGD3875 takes the bigger post.

Whichever side wins, size the driver to the post first: the collar or inside diameter has to fit, or nothing else matters.

Around the Barn

  • Slide a hand driver straight down over the post before the first lift, so it cannot glance off sideways.
  • Match the adapter collar to the post diameter before starting a gas driver.
  • Use the integrated stop switch to shut the PGD3875 down; do not wrestle a running driver.
  • Store hand drivers dry on a shelf; the LADECH listing notes its simple design takes up little space.
  • Check the fence line each morning before turning goats out.

FAQs from goat keepers

Is a hand or gas post driver better for a small goat fence?

For a short run of T posts, the hand side wins on simplicity: the 12 lb LADECH needs no fuel. For a long perimeter or hard ground, the gas side wins with its 1.3 HP 4-stroke engines.

How heavy is a hand post driver?

The two hand listings state 12 lbs and 34 lb. The MTB spec table says 18 pounds, but the title and bullets say 34 lb and win.

What size posts can a gas post driver handle?

The PGD3875 drives posts up to 3 7/8 inches with 1, 2, 3 and 4 inch collars; the PGD2875 fits posts up to 3 inches with 1, 1.77, 2 and 3 inch collars.

Do gas post drivers need fuel and oil?

Yes, both Titans are 1.3 HP 4-stroke gas engines. The PGD2875 box includes engine oil and extra lube.

Can a hand post driver set wooden posts?

The MTB listing names wooden posts plus T posts and U posts, with a 6.14 inch inside diameter. The LADECH listing names only metal U posts, T posts and garden fence.

Titan PGD3875 Gas
Still deciding? Our top pickTitan PGD3875 Gas
Check price on Amazon

Behind the Farm Score

Product GoatGear Score Perf. /35 Build /25 Value /25 Safety /10 Warranty /5
Titan PGD3875 Gas 9.5 30 21 19 4 0
Titan PGD2875 Gas 9.4 29 20 20 0 0
LADECH 12 Lb Hand 9.4 26 19 20 0 0
MTB 34 Lb Hand 9.3 27 19 18 0 0

Our scores stay inside 9.2 and 9.8, with point totals stretched across that gap evenly, so the item with more points shows the bigger score.

The GoatGear Score weighs performance, build, value, safety and warranty. Safety points need a stated safety-relevant feature: the Titan PGD3875 earns them with its integrated stop switch; the other three state no safety feature and none states a warranty term. The PGD3875 leads on engine power and post size, the PGD2875 on light weight for a gas unit, the LADECH on manual value, and the MTB loses points for a spec table that contradicts its own title.

More from the barn

See every post driver guide and all fencing and shelter guides.

More picks: T post drivers for clay soil, post driver vs auger, post drivers for wood posts and gas vs battery post drivers.