
On this page
Top picks at a glance
As an Amazon Associate I earn from qualifying purchases.
- 1
EFencSolv Step-In Electric Fence Posts9.7/10View on Amazon - 2
VEVOR 6 ft U-Channel Metal Fence Post9.7/10View on Amazon - 3
CLEASO 6FT Green U-Channel Fence Posts9.7/10View on Amazon
A goat leans into the fence every morning, and the posts along that line decide whether the wire stays tight or starts to sag toward the pen. This guide answers t post vs u channel fence posts directly: for a goat fence built from the posts listed here, a U-channel post is the practical pick, because every product listed is a U-channel post and none of them is a T-post. The choice that matters is which U-channel post fits the job, and the sections below compare the listed posts on length, pack size, weight, holes and mounting so the pick is clear.
GoatGearLab earns a commission when you buy through links on this page, at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Affiliate disclosure.
T post vs U channel fence posts: the short answer
For goat wire fencing, the Gtongoko 6 foot U-channel post in a 10 pack is the pick from this set, because it is the only listed post with studded tabs for fastening wire fence, plus a welded anchor plate. The other three listed posts are sign posts, with pre-drilled holes for mounting signs. A sign post holds a sign, and a fence post holds wire, so match the post to the job before ordering. For more on the T-post side of the question, see T post fence ideas, and for the wider fence question see best fence for goats.
The U-channel posts compared
| Post | Length | Pack | Weight | Mounting |
|---|---|---|---|---|
| Gtongoko U Channel Fence Post | 6 feet | 10 pack | 2.62 pounds | Anchor plate, studded tabs, pointed bottom |
| Brimar U Channel Sign Post | 8 feet | 4 pack | 1.1 pounds per foot | Pre-drilled holes on 1 inch centers, top 30 inches |
| SmartSign U-Channel Sign Post | 7 feet | 1 post | 1.12 pounds per foot | Pre-drilled holes 1 inch apart, hardware included |
| VEVOR U-Channel Sign Post | 8 feet | 4 pack | 41.01 pounds | 30 pre-drilled holes, 8 sets of screws |
Sizes and capacities are the manufacturer’s numbers as each listing states them.
Gtongoko 6 foot U-channel fence post, 10 pack
The Gtongoko post is the fence post of this set. The maker lists a U-channel steel shape that resists bending, a welded anchor plate for ground grip, and studded tabs that fasten welded wire fence, chicken wire, field fence and garden mesh. The pointed bottom drives into soil with a hammer or post driver, with no digging or concrete, and the maker lists garden, farm, orchard and backyard uses plus pet enclosures and chicken runs. The maker lists a weight of 2.62 pounds. For a goat pen that needs wire held tight, this is the post that matches the job as listed.
Brimar 8 foot U-channel sign post, 4 pack
The Brimar post is a sign post in an 8 foot length, sold as a 4 pack in green steel with a baked enamel coating. The maker lists high-tensile steel, a weight of 1.1 pounds per foot, and pre-drilled holes of 3/8 inch on 1 inch centers along the top 30 inches for signs up to 12 by 18 inches. The maker recommends burying the post 18 to 24 inches into the ground, depending on soil. For a sign beside the goat pen, the Brimar post covers the mounting with holes placed for alignment.
SmartSign 7 foot U-channel sign post
The SmartSign post is a single 7 foot post in green baked enamel steel, 2-1/4 inches wide, with pre-drilled holes of 3/8 inch spaced 1 inch apart from top to bottom. The maker lists a weight of 1.12 pounds per foot and calls it medium weight, suited to signs of 12 by 18 inches or smaller, with a tapered end for mounting. The kit includes 2 bolts, 2 nuts, 2 metal lock washers and 2 plastic washers. For one sign at a gate, the SmartSign post arrives with its mounting hardware in the box.
VEVOR 8 foot U-channel sign post, 4 pack
The VEVOR post is an 8 foot galvanized steel post in a 4 pack, with 30 pre-drilled holes of 0.39 inch, or 10 mm, per post and 8 sets of screws for fixing. The maker lists Q235 steel with a corrosion-resistant coating and a green finish, and the pack includes 8 external hexagon bolts, 8 flat washers, 8 spring washers, 8 nuts and 1 instruction manual. The maker lists the item at 41.01 pounds. For a run of signs, the VEVOR pack covers the count, and the length mismatch in the listing deserves a check before ordering, as noted below.
Reading length, weight and pack size
Length decides how much post stands above the ground and how much sits below it, and the listed lengths run from 6 feet on the Gtongoko post to 8 feet on the Brimar and VEVOR posts, with the SmartSign post at 7 feet. Pack size decides how far one order goes: the Gtongoko post comes as a 10 pack, the Brimar and VEVOR posts as 4 packs, and the SmartSign post as a single post with hardware. Weight is listed three ways here: the Gtongoko maker lists 2.62 pounds, the Brimar maker lists 1.1 pounds per foot, the SmartSign maker lists 1.12 pounds per foot, and the VEVOR maker lists 41.01 pounds for the item. A per-foot figure and a per-item figure are not the same measure, so read the unit beside each number before ranking the posts on weight.
Mounting: no-dig, anchor plates and pre-drilled holes
Mounting splits this set into two groups. The Gtongoko post drives in with a hammer or post driver through its pointed bottom, and the welded anchor plate grips the soil once the post is set, with no digging or concrete. The VEVOR post also pushes into the ground without special tools or strenuous digging, with a hammer for hard surfaces. The sign posts mount differently: the SmartSign and Brimar posts carry pre-drilled holes of 3/8 inch, so signs bolt on at the height the holes allow. The Brimar maker recommends burying the post 18 to 24 inches into the ground, and the guide how deep should a fence post be covers depth in more detail. Studded tabs suit wire, pre-drilled holes suit signs, and the anchor plate suits a post that must hold its place under a leaning goat.
Materials and coatings
All four listed posts are steel with a coating. The Gtongoko post is steel with a U-channel shape and a green finish. The SmartSign post is baked enamel steel in green, which the maker says helps prevent rust. The Brimar post is high-tensile steel with a corrosion-resistant baked enamel green coating. The VEVOR post is galvanized steel Q235 with a corrosion-resistant coating and a green finish. For a damp pen, the coating is the line to read, and the listings name baked enamel and galvanized coatings rather than bare steel.
Read the listing twice
The VEVOR listing gives two lengths: the title gives 8 feet, while the accessories line gives 6-foot posts. The maker gives 30 pre-drilled holes per post and 8 sets of screws either way, so the count is steady and the length is the part to check before ordering. Measure the run and the gate height before ordering, and allow for the larger figure where a listing gives two.
What this guide does not cover
This guide covers post hardware only. It does not cover wire types, fence chargers or how much fence a herd needs, and it does not cover animal health or veterinary questions. Ask a veterinarian or local extension office about goat health.
FAQs from goat keepers
Are U-channel posts strong enough for a goat fence?
The Gtongoko post is the listed pick for wire fencing: the maker lists a U-channel steel shape that resists bending, a welded anchor plate and studded tabs for welded wire, chicken wire and field fence. The other three listed posts are sign posts, so judge them on sign mounting.
How deep should a U-channel post go into the ground?
The Brimar listing recommends burying the post 18 to 24 inches into the ground, depending on soil. The other listings do not state a burial depth, so the Brimar figure is the only depth stated here.
What is the difference between a T-post and a U-channel post?
This guide lists four U-channel posts and no T-post, so no T-post length, weight or pack size is stated here. The U-channel posts listed here share a channel shape, and the Gtongoko post adds an anchor plate and studded tabs for wire, while the sign posts add pre-drilled holes for mounting signs.
Do these posts need concrete?
The Gtongoko listing describes installation with no digging or concrete, driven in with a hammer or post driver. The VEVOR listing describes pushing the posts into the ground without special tools or strenuous digging. The Brimar and SmartSign listings do not state whether concrete is needed.
Which U-channel post suits a run of signs?
The VEVOR post comes as a 4 pack with 30 pre-drilled holes per post and 8 sets of screws, and the Brimar post comes as a 4 pack with holes along the top 30 inches. The SmartSign post is a single post with 2 bolts, 2 nuts, 2 metal lock washers and 2 plastic washers in the kit. Check the VEVOR length mismatch noted above before ordering.
More from the barn
See every goat fencing guide and all fencing and shelter guides.
More picks: best fence for goats, T post fence ideas, how deep should a fence post be and best concrete mix for fence posts.
