Skip to content
We independently pick everything we recommend. We earn a commission when you buy through our links, at no extra cost to you. Learn more ›
Amazon Black Friday Week deals

How to Lay Out Fence Posts Straight

How to lay out fence posts: set corner posts, pull a mason line tight between them and mark each post spot along the string before any hole is dug.

Top picks

As an Amazon Associate I earn from qualifying purchases.

How we score

How to Lay Out Fence Posts Straight
On this page

Top picks at a glance

As an Amazon Associate I earn from qualifying purchases.

  1. 1Gulfmew Mason Line String KitGulfmew Mason Line String Kit9.5/10View on Amazon
  2. 2CimoroWin 72-Pc Fence KitCimoroWin 72-Pc Fence Kit9.4/10View on Amazon
  3. 3CimoroWin 53-Pc Fence KitCimoroWin 53-Pc Fence Kit9.3/10View on Amazon
  4. 4Taytools Framing Square FenceTaytools Framing Square Fence9.2/10View on Amazon

A goat leaning on a fence line that wanders like a snake shows why how to lay out fence posts matters before the first hole is dug. A straight line starts with corner posts, a string pulled tight between them and marks for every post in between, and the gear below covers the string, the stakes and the insulators that finish the line.

GoatGearLab earns a commission when you buy through links on this page, at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Affiliate disclosure.

Gulfmew Mason Line String Kit

Gulfmew Mason Line String Kit

Gulfmew9.5/10 GoatGear Score
i
The GoatGear Score runs from 0 to 10 and weighs performance (35%), build (25%), value (25%), safety (10%, where it applies) and warranty (5%), using only what the manufacturer and the listing publish. How we pick ›

A string, stake and level kit that marks the fence line and keeps it straight while posts go in.

Pros

  • 42 stakes, a 540 ft line and 5 levels in one kit
  • Bright orange line and red levels for visibility
  • Line rated to a 132 lb weight capacity
  • Stakes suit marking fence lines and garden beds

Cons

  • Wooden stakes may show knots and pine oil stains
  • No warranty term is stated
  • No charger, wire or insulators for the fence itself
CimoroWin 72-Pc Fence Kit

CimoroWin 72-Pc Fence Kit

CimoroWin9.4/10 GoatGear Score
i
The GoatGear Score runs from 0 to 10 and weighs performance (35%), build (25%), value (25%), safety (10%, where it applies) and warranty (5%), using only what the manufacturer and the listing publish. How we pick ›

An electric fence kit whose T-post and wood-post insulators fit the posts once the line is laid out.

Pros

  • Insulators for both T-posts and wood posts
  • 0.25 joule charger covering up to 5 miles or 20 acres
  • 250 ft of 17 gauge aluminum wire included
  • Red pulse light shows working status

Cons

  • Ground rod required separately
  • Needs an outlet, so the line must run near power
  • No warranty term is stated
  • Charger and wire come after layout, not during it
CimoroWin 53-Pc Fence Kit

CimoroWin 53-Pc Fence Kit

CimoroWin9.3/10 GoatGear Score
i
The GoatGear Score runs from 0 to 10 and weighs performance (35%), build (25%), value (25%), safety (10%, where it applies) and warranty (5%), using only what the manufacturer and the listing publish. How we pick ›

An electric fence kit with 50 insulators and a socket tool for the wire runs after posts are set.

Pros

  • 0.25J charger for a 5-mile fence
  • 250 ft of 14AWG aluminum wire included
  • 50 insulators with a socket tool
  • Wire rated at 38,000 PSI with a 90 lb breaking load

Cons

  • Ground rod required separately
  • Needs 110VAC power near the fence line
  • No warranty term is stated
  • Fewer insulators than the larger CimoroWin kit
Taytools Framing Square Fence

Taytools Framing Square Fence

Taytools9.2/10 GoatGear Score
i
The GoatGear Score runs from 0 to 10 and weighs performance (35%), build (25%), value (25%), safety (10%, where it applies) and warranty (5%), using only what the manufacturer and the listing publish. How we pick ›

A carpenter's square fence for marking right angles on lumber, not a fence-post tool.

Pros

  • Anodized aluminum with brass thumb screws
  • Fits either arm of a framing square
  • 1 inch fence on one side, 1/4 inch on the other
  • Acts as a handle for the square

Cons

  • Made for lumber, not for fence posts
  • No use in marking a post line in the field
  • No warranty term is stated
  • Fits squares only up to 3/16 inch thick

As an Amazon Associate I earn from qualifying purchases.


Also worth comparing

How to lay out fence posts: the short answer

Set the corner posts first, then pull a string line tight between them and mark each post spot along the string. Check the corners for square, walk the line and move any mark that drifts off the string, and only then dig. The string, stakes and levels in the gear section mark the line, and the insulators in the fence kits fit the posts once the line is set.

Set the corners first

Corners decide the whole line, so set them before anything else. Drive a corner post at each end of the run and brace it so it stays put while you pull the string. A corner that moves after the string is up pulls the whole line with it, so check each corner before moving on. Once the corners hold, the line between them is the fence.

Pull a string line between the corners

Tie a mason line to one corner post and pull it tight to the other end, then fix it so it stays taut. The Gulfmew kit (on Amazon) in the gear section gives a 540 ft line with a handle, 42 wooden stakes and 5 built-in levels, which covers the string, the stakes and the level in one kit. Walk the line and look along it: a sag or a bow means the line needs tightening or a stake moved. Keep the line clear of grass and brush so it reads true.

Mark each post spot along the string

With the string taut, mark each post spot on the ground beside the line, spacing the marks evenly from corner to corner. A stake at each mark holds the spot while you work down the line, and the mason line shows at a glance which marks drift. Move a drifting mark back to the string before you dig, since a post set off the line stays off the line.

Set the posts and fit the insulators

Once the marks sit on the string, set the posts on the marks and check them against the line as you go. The CimoroWin kits in the gear section carry insulators for both common post styles: the 72-piece kit has 20 T-post insulators and 50 slant nail-on insulators for wood posts, while the other kit has 50 insulators with a socket tool. Fit the insulators after the posts are set and plumb, then run the wire. Both charger kits need a ground rod, sold separately, and proper grounding is essential. See the types of electric fence for the fence styles these kits suit.

The gear for laying out fence posts

The string kit marks the line, the fence kits carry the insulators that fit the posts, and the square fence belongs on a workbench rather than a fence line.

Read the listing twice

The Gulfmew listing calls its stakes 12 inch in the title and lists a stake height of 11.81 inches in the bullets, so allow for the smaller figure when you plan. The CimoroWin 72-piece kit lists its wire as 17 gauge in the title and 17 gauge / 1.40 mm in the bullets, which agree. The Taytools listing gives its length as 7-7/8 inches in the bullets and 7.875 inches in the spec table, which agree.

What this guide does not cover

This guide covers laying out the line only. It does not cover digging post holes, setting posts in concrete or wiring an energizer. Ask your local extension office about fence rules and goat containment for your area.

FAQs from goat keepers

How do I keep a fence line straight?

Pull a mason line tight between set corner posts and mark each post spot along it. The Gulfmew kit gives a 540 ft line, 42 stakes and 5 levels for marking the line and checking it as you go.

What marks the post spots?

Stakes mark the spots. Drive a stake at each mark beside the string so the spot holds while you work down the line, then set each post on its mark.

Do electric fence kits help lay out posts?

Only in part. The CimoroWin kits carry insulators that fit T-posts and wood posts, but the charger and wire come after the posts are set. Lay out the line with string and stakes first, then fit the insulators.

Can a framing square lay out fence posts?

No. The Taytools fence (on Amazon) fits a carpenter’s framing square for marking lumber, with a 1 inch fence on one side and a 1/4 inch fence on the other. It has no use on a post line in the field.

Gulfmew Mason Line String Kit
Still deciding? Our top pickGulfmew Mason Line String Kit
Check price on Amazon

More from the barn

See every goat fencing guide and all fencing and shelter guides.

More picks: how to dig a fence post, post hole digger tips, how to level fence post and best plug in electric fence chargers.