
On this page
Top picks at a glance
As an Amazon Associate I earn from qualifying purchases.
- 1
Fixum Chain Link Fence Stretcher Tool for 2-3/8 in OD Posts9.6/10View on Amazon - 2
Fixum Chain Link Fence Stretcher Tool9.7/10View on Amazon - 3
HOTYELL Chain Link Fence Stretcher9.7/10View on Amazon
The fence line leans where the goats push against it every morning, and a post for fence installation is the upright that carries the wire and holds that line straight. This guide explains post types, drivers, sleeves and fit, using only figures the reference listings state. Read the listing twice before ordering, because the numbers in these listings do not always agree.
GoatGearLab earns a commission when you buy through links on this page, at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Affiliate disclosure.
Post for fence installation: the short answer
Start with the post, then pick the driver. A metal T-post goes in with a gas T-post driver or a jackhammer system, and a wood post goes in with the same drivers, since the HIGOSPRO listings state they work with all standard T-posts, metal and wood. Match the sleeve to the post, check the impact energy and the weight, and read the listing twice for conflicting numbers.
If you would rather go straight to the tool, how to use a post driver walks through the steps on a fence post.
Drivers that set the post
| Driver | Sleeves | Impact energy | Weight |
|---|---|---|---|
| JKCHEN PRO 52cc | 49mm, 69mm, 100mm | 55J | 42.0 pounds |
| HENHAIY 32.6cc | Not stated | 20-45J | 28.66 pounds |
| HIGOSPRO 37.7cc, 2 sleeves | 55mm, 70mm | 35J | 15.4 pounds |
| HIGOSPRO 37.7cc, 3 sleeves | 45mm, 55mm, 88mm | 35J | 15.4 pounds |
| Generic T-Post Driver System | 30mm hex shank | 60 Joule | 49.5 pounds |
Gas T-post drivers
The gas drivers in these listings are the JKCHEN PRO 52cc (on Amazon), the HENHAIY 32.6cc (on Amazon) and the 2 HIGOSPRO 37.7cc models. The JKCHEN PRO lists 1900W and 55J of impact energy at 6500 RPM, and it ships with 49mm, 69mm and 100mm sleeves. The HENHAIY lists 900W and 20-45J of impact energy, and the HIGOSPRO models list 1200W and 35J at 8500 RPM. The JKCHEN PRO and the HENHAIY are 2-stroke engines, and the HIGOSPRO models are 4-stroke engines.
Gas drivers suit a long fence line where no outlet is in reach, and the listings name farm fencing, highway guardrails, vineyards and orchards among their uses. The JKCHEN PRO listing also names construction, and the HENHAIY listing names gardening, road fencing and geophysical exploration. Pick the driver by the post and the ground, not by the engine size alone.
The jackhammer system
The remaining listing is the Generic T-Post Driver System (on Amazon), which pairs a PH-65B jackhammer with a collar and a bit. The listing calls it the only powered T-post driver that you never have to lift over your head. The jackhammer lists 120 Volt, 1700 Watt, a 14.2 amp draw, 1900 BPM and 60 Joule impact energy, with a 30mm hex shank.
The collar is forged, heat-treated and chrome-plated steel, and it fits all gauges of T-post from light-duty 0.83 lb/ft to heavy-duty 1.5 lb/ft, as well as Y-posts with teeth. The listing states a 100% lifetime guarantee on the jackhammer, collar and bit, while the boxes are not covered under warranty. It also states the system will not drive posts through solid rock or concrete.
Sleeves, post size and fit
Sleeves decide whether the driver fits the post. The JKCHEN PRO ships with 49mm, 69mm and 100mm sleeves, the HIGOSPRO 2-sleeve model ships with 55mm and 70mm sleeves, and the HIGOSPRO 3-sleeve model ships with 45mm, 55mm and 88mm sleeves. The HENHAIY listing states no sleeve size. The Generic system uses a 30mm hex shank and a collar that fits T-posts from 0.83 lb/ft to 1.5 lb/ft, plus Y-posts with teeth.
Post type matters as much as size. The HIGOSPRO listings state they work with all standard T-posts, metal and wood, and the JKCHEN PRO listing names metal and wood posts too. Check the post before ordering, and match the sleeve to the post rather than to the driver.
Power and impact: watts, joules and RPM
Power on these listings is stated in watts, impact energy in joules and speed in RPM, and the figures vary widely. The JKCHEN PRO lists 1900W, 55J and 6500 RPM. The HENHAIY lists 900W and 20-45J, with a title speed of 8500r/min and an impact frequency of 1200-2200r/min in the bullets. The HIGOSPRO models list 1200W, 35J and 8500 RPM. The Generic jackhammer lists 1700 Watt, 60 Joule, 1900 BPM and a 14.2 amp draw on 120 Volt.
Read watts and joules together: watts describe the engine, joules describe the hit. The listings here run from 20-45J to 60 Joule, so compare the stated figures against the posts and ground you have. The HIGOSPRO listings also claim 40% less vibration than standard models, a maker claim with no baseline stated, so treat it as a claim, not a measurement.
Weight and handling
Weight decides how long you can work with a driver before your arms give out, and the listings here span a wide range. The HIGOSPRO models list 15.4 pounds, the HENHAIY lists 28.66 pounds, the JKCHEN PRO lists 42.0 pounds and the Generic system lists 49.5 pounds.
Handles matter as much as weight. The HENHAIY lists double handles wrapped in soft sponge for grip, the HIGOSPRO models list a shock-absorbing rubber handle, and the Generic system lists a shock-absorbing, vibration-dampening main handle with a trigger switch for one-handed operation. The JKCHEN PRO lists a shock-absorbing rubber-plastic handle and cooling vents that prevent overheating during prolonged use.
Fuel, oil and runtime
Gas drivers need fuel, oil and a mix ratio, and the listings state them differently. The JKCHEN PRO lists a 1.3L fuel tank, a 0.6L/h consumption rate and a 25:1 gas/oil mix. The HENHAIY lists a 0.23gal translucent fuel tank. The HIGOSPRO models list a 0.65L fuel capacity and 0.47L/kW·h efficiency. The Generic system is electric, so it lists no fuel tank: it runs on 120 Volt and ships with a 4-oz bottle of jackhammer oil.
None of these listings states a runtime in hours or a number of posts per tank, so plan fuel by the tank size and the consumption rate the listing states, and keep oil on hand for the mix.
Read the listing twice
Fence driver listings often contradict themselves, and the numbers that conflict are usually the ones you need to plan the install:
- HENHAIY: 32.6cc in the title against 32.7cc in the bullets, and 8500r/min in the title against an impact frequency of 1200-2200r/min in the bullets.
- HIGOSPRO: 40% less vibration than standard models, with no standard model named and no baseline figure stated.
- Generic: a 100% lifetime guarantee on the jackhammer, collar and bit, while the boxes are not covered under warranty, and a claim to be the only powered driver you never have to lift over your head.
- JKCHEN PRO: a lightweight frame, while the spec table lists 42.0 pounds.
Measure your post before ordering and allow for the larger sleeve. Some listings also claim to reduce operator fatigue; those are maker claims, and a driver is equipment, not a health product.
What this guide does not cover
This guide covers post drivers, sleeves and fit only. It does not cover fence wire, electric fence chargers or how far apart to set posts, because none of these listings states those figures. Ask your local extension office about fence layout and wire for your ground.
FAQs from goat keepers
What size sleeve fits a T-post?
Match the sleeve to the post. The JKCHEN PRO ships with 49mm, 69mm and 100mm sleeves, the HIGOSPRO models ship with 55mm and 70mm or 45mm, 55mm and 88mm sleeves, and the Generic collar fits T-posts from 0.83 lb/ft to 1.5 lb/ft. The HENHAIY listing states no sleeve size.
How much power does a gas T-post driver need?
The listings state 900W, 1200W and 1900W, with impact energy of 20-45J, 35J, 55J and 60 Joule. No listing states a minimum for any ground type, so compare the stated figures against the posts and ground you have.
Can a T-post driver set wood posts?
Yes, per the listings. The HIGOSPRO listings state they work with all standard T-posts, metal and wood, and the JKCHEN PRO listing names metal and wood posts. The Generic system states it will not drive posts through solid rock or concrete.
How heavy is a gas T-post driver?
The HIGOSPRO models list 15.4 pounds, the HENHAIY lists 28.66 pounds and the JKCHEN PRO lists 42.0 pounds. The Generic jackhammer system lists 49.5 pounds.
Do T-post drivers come with a warranty?
The JKCHEN PRO and HIGOSPRO listings state a 1 Year warranty, and the Generic system states a 100% lifetime guarantee on the jackhammer, collar and bit, with the boxes not covered. The HENHAIY listing states no warranty.
More from the barn
See every goat fencing guide and all fencing and shelter guides.
More picks: how to install T-post fence, manual T-post drivers, how to use a post driver and easy install fence posts.
